 |
|
 |
|
 |
| |
|
|
 |
|
| |
AZETA
AIR MIX air-oil lubrication system
|
 |
| |
|
|
 |
|
|
A minimal lubrication system
operating on ultra low
oil consumption. Compressed
air is used as a carrier.
Metered oil, suitably mixed
with air, is conveyed in
non atomised state to the
lubrication point. AZETA
AIR MIX is especially recommended
for lubrication of high
speed rolling contact bearings
on spindles, electro-spindles
and of rotating bushes
of lathes with sliding
headstock. For linear guides,
the continuous flow keeps
clean the tracks and races
of balls or slides, as
well as the contact races
of rolling contact bearings.
|
|
single
and combinable mixers |
|
|
| |
|
|
 |
|
Built for using:
single or combinable
Lubricant air connection:
for Ø 6 (Ø8-Ø4) pipe
Lubricant air adjusting:
single, by screw
Lubricant air nominal flow rate:
from 0 up to 200 liters/min
(nom. Ø 2) |
The
ultra high speed, powerful,
precise movements of
today’s machine tools
call for optimal, long-lasting
and
clean lubrication.
The AZETA new system ensures
this after many years of
tests on its own machine tools.
|
|
Maxing unit base
Built in 5 models
for 2-3-4-5-6 mixing units
Network air connection:
1/4" G at 2 ends
Wall fastening |
 |
|
Built for using:
single or combinable
Lubricant air connection:
for Ø 6 (Ø8-Ø4) pipe
Lubricant air adjusting:
single, by screw
Lubricant air nominal flow rate:
from 0 up to 200 liters/min
(nom. Ø 2) |
The
AIR
MIX system is a minimal
lubrication air-oil system,
with low oil consumption. The
oil is dosed intermittently,
while the flow of air is continuous.
These two elements
produce a very fine lubricating
mixture that uses air as a
carrier. The quantity of oil
comes within a value, in many
cases even lower, of 10-7 compared
to the air, per unit of
time.
This mixture can be modified
with the flow rate of the
dosing valve and the number
of operations-hour according
to the requirements of lubrication
or lube cooling.
 |
|
Maxing unit base
Built in 5 models
for 2-3-4-5-6 mixing units
Network air connection:
1/4" G at 2 ends
Wall fastening |
|
|
single
and combinable mixers with valve
for check occlusion |
|
|
| |
|
|
 |
|
Valve for check of lubricant air channel occlusion:
single, for each mixing unit.
One-way combinable connection:
for check of lubricant air occulsion from one point only.
Pressure switch :
for channel/s occlusion alarm signal.
|
The
AIR
MIX system with occlusion
check is different from
the basic version in the mixer
modules, which have the
addition of a special valve
in line with the lubricant
air
duct. The mixer module with
the occlusion check valve
can be used on its own or combinable,
fitted on a mixing
unit base.
Its being combinable also allows
mixed use of mixers with
or without occlusion check
valves, following the rule
of
keeping the modules side by
side with the valve for the
combinable connection.
|
|
Check
valve on lubricant oil
connection :
for single mixing unit (necessary for lubricant air pressure higher than
1,5/2 bar) |
|
|
mixers
with micropump |
|
|
| |
|
|
 |
|
|
The
AIR
MIX with Micropump system is different from
the
basic version as concerns the
oil injection that takes place
with a micropump, replacing
the dosing valve, installed
at the oil inlet of the mixer
module. The mixer module with
micropump can be used on its
own or combinable, fitted
on a mixing unit base.
The micropump is a true volumetric
pneumatic plunger
piston pump, governed by a
single-acting pneumatic
cylinder with spring return.
The supply of oil to the
micropumps takes place by gravity
from a reservoir set at
a greater height.
|
|
|
air mist EVO 2 |
|
|
| |
|
|
 |
|
|
AZETA
AIR MIX EVO2 comprises
an air-oil lubrication
unit
with two channels with mixer
modules and micropumps,
complete with all the accessories
for the timed electric
control, ready for use.
The AIR MIX system is a minimal
lubrication air-oil system,
with low oil consumption. The
oil is dosed intermittently,
while the flow of air is continuous.
These two elements
produce a very fine lubricating
mixture that uses air as a
carrier. The quantity of oil
comes within a value, in many
cases even lower, of 10-7 compared
to the air, per unit of
time. This mixture can be modified
according to the
requirements of lubrication
or lube cooling.
|
|
|
| |
|
|
|
|
|
| |
|
AZETA ZEO ASIOLI DIFFUSION SRL |
|
|
|
Via Bellelli, 2 - 42015 CORREGGIO (RE) - Italy - Tel. e Fax +39 0522 690156 |
|
|
|
|
|
|
|
|
